Aimedia Bath Reheating Pipe Cleaner, 2 Uses

Product Overview

A two-part cleaner for bath reheating pipes, combining a foaming aid with an instantly foaming boost powder to clean deep inside the pipes. It can also clean and sanitize bathroom accessories by soaking them in the bath. Contains enough for 2 uses.

Features

• Each of the 2 sets contains one 78g sachet of foaming aid and one 222g sachet of boost powder.
• Cleans mold, grime, sludge, and slimy buildup from bath reheating pipes.
• Provides cleaning and sanitizing action. Does not eliminate all bacteria.
• Works with compatible single-hole and two-hole bath reheating systems.
• Foaming aid: acidic. Boost powder: mildly alkaline.
• Made in Japan.

Ingredients

Foaming aid: citric acid.

Boost powder: sodium percarbonate, surfactant (sodium alpha-olefin sulfonate), alkaline agent (sodium carbonate), foaming agent (sodium bicarbonate), enzymes.

How to Use

Dosage: Use the entire contents of one set of foaming aid and boost powder for one cleaning session with approximately 100L of water or bathwater.

Cleaning single-hole and two-hole systems: Fill the bath with water or remaining bathwater to approximately 5cm above the opening. Do not use bathwater containing bath additives. Leave the bath filter in place, if fitted, to keep hair and debris out. Add the entire foaming aid sachet. Slowly add the boost powder near the opening, holding it close to the water surface to reduce airborne powder. Run the reheating function for approximately 10 minutes to bring the water to around 40°C, then leave for 4 hours to overnight. Do not leave for 24 hours or longer.

Rinsing a single-hole system: Drain completely, close the drain, and refill with water to approximately 5cm above the opening. Run the reheating function for approximately 10 minutes, then drain completely. Remove any remaining dirt from the bath with a sponge and rinse thoroughly with the shower.

Rinsing a two-hole system: Direct a strong stream of water from a hose into the lower opening to flush out dirt and sludge, then drain the bath completely. Use the shower if a hose is unavailable. Flush out all sludge, as remaining buildup may emerge during bathing. Rinse the bath thoroughly with the shower.

Cleaning bathroom accessories: During the soaking stage, place items such as bath stools, washbasins, bath covers, and plastic toys in the bath and soak for at least 6 hours. Do not leave for 24 hours or longer. Remove and rinse thoroughly. Scrub any remaining dirt with a sponge.

Use every 1–2 months to maintain cleanliness. Keep your face away when opening the sachets, as powder may become airborne.

FAQ

Q: Which bath systems can this cleaner be used with?
A: It can be used with systems that have a reheating function and allow a fixed water temperature to be set, including compatible two-hole systems and EcoCute heat-pump water heaters. It can also be used with whirlpool and 24-hour bath systems whose filtration does not use bacteria. Read the water heater's instruction manual, as cleaning methods vary by system.

Q: Where should it not be used?
A: Do not use it with bath heaters without a reheating function, painted bathtubs, systems with bacteria-based filtration, wooden or marble bathtubs (natural or artificial stone), or aluminum or copper items.